Fractal Design Meshify C - Compact Mid Tower Computer Case - Airflow/Cooling - 2x Fans included - PSU Shroud - Modular interior - Water-cooling ready - USB3.0 - Tempered Glass Side Panel - White

I did a case swap into this case (previous case was a GameMax Vanguard VR2 and my first PC build), and this case was such a pleasure to build in in comparison. Highly recommend it for newbie builders as it comes with a manual and all screws are labelled inside which you may not find in cheap cases. Visually I think it's gorgeous, I have the white version and it looks very sleek and elegant with the mesh front panel. One of the reasons I swapped is because I wanted a smaller, lighter case, and this one is a nice size and weight without being cramped or flimsy. The reduced space does make certain things more difficult, for example fitting the SATA cables into my ATX motherboard was difficult because there wasn't much room at the side for me to access the slots. I also had to arrange my power supply cables carefully because the cables are round and very thick, but overall I found managing cables to be quite easy. One of the things I love about it the most are the hard drive trays - my last case had my 7200 drives rumbling like crazy, I even replaced one because I thought it was faulty. But in this case I can only hear my drives when I'm holding my ears up to the case which is a crazy difference to the tooth-grating sound I had to deal with before. It has little rubber pads on the tray which the drive sits on and they work great. Overall, I love this case, I can't stop admiring it, it was well worth re-building my PC.

I just built my new gaming PC and I really enjoy this computer case! It's surprisingly light (probably because it is slightly smaller than expected), looks really pretty, and quite easy to fiddle around with! You get two stock fans which seem to be working just fine, and you get a few cables too + cable ties and velcro + dust filters below, on-top and in the front. The case came pre-built, so there's not really much building to do besides inserting computer parts. The cable management in this is pretty good too; tons of open spaces to get your cables through. As for heat issues, I haven't run into any, and I'd like to think the case helps out with that. I manage to run my games on really high fps without touching 60*C yet. My only issue with this case is that I had some issues getting my storage trays inside after inserting my SSD; along with cable management within the power supply area. I had to watch a few tutorials to figure it out, though now that it's all done and good, it doesn't bother me much. Can def recommend! : >

I bought this case after a cheap one I ordered off Amazon was damaged in transit. In getting a refund, I decided to use the opportunity to rethink and instead purchase a more expensive case, in the hopes it would be a little more 'future proof' and hopefully easier to assemble (the previous case came with no instructions, to my horror). Thankfully, the Fractal Design Meshify C comes with beautifully clear instructions, written in unbroken English and with clear diagrams. All in all, it took about an hour and a half to get my new case-less PC set up inside the case. It was a really easy build (especially considering this was my first PC) with lots of room inside and good cable management solutions. I went for the white version to complement my PS5 and offer some contrast against the mostly black and red motherboard I use, and it looks great. Would certainly recommend!

After extensive searching for a white case which I liked aesthetically and also provided good airflow I finally found this. I wasn't fond on glass fronted cases I wanted mesh but there aren't many out there that look modern. The case is well built and sturdy, it definitely feels well made at every part, the glass panel is nice and comes with a sheet over to protect it which I have left on thus far. It was very easy to build it, enough space for each component and plenty of room for cable management. I can't comment on the fans as I replaced them instantly but it's good that some come with the case in case you don't have any. I haven't had any heating issues and airflow seems to be good. I'd definitely recommend this case I'm so glad of my choice

The Fractal Deaign Meshify C is an excellent case. It’s well built and can easily fit a 360 and 240mm rad for custom loop cooling. I would recommend a thin rad like the Nemesis GTX or XSPC TX range. This unit is more expensive than buying directly from Scan, hence the 4 stars, but I had Amazon vouchers so hey ho. I’m delighted with the case, it looks great, is missing friendly and the unusually short form factor significantly reduces the footprint for shallower desks. The build quality is high, and the unit is sturdy. I’m not a great fan of the mounting for the glass panel, but the SSD mount, removable shroud plate, pci screw cutouts, captive screws and removable drive cage are all nice touches. Be cautious of GPU length as there’s only 315mm available with a front fan, and by the time you add a 30mm radiator your down to 285mm. Fortunately my blocked up gigabyte 1080 G1 gaming fits fine. The front mesh offers superb airflow and is easy to remove, as is the full cover bottom filter. The top filter feels a little chincy, but then it should only really be used for exhaust so no problem there. One issue I ran into is my ASUs ROG X Formula fouled on the grommets when fitting the front USB3, I had to file out the grommet hole to make it fit, so be careful which board you choose. Overall I highly recommend it, especially if space is limited. For the price it’s a bargain.

This case is simply amazing, it's a brilliantly well made peice of kit for a fair price. I am limited on size where my PC is located so this refined and compact (full ATX MB though) case was amazing. The cable management means your PC looks neat and tidy and access to all the ports are perfect. I love my case, HD audio ports at the front, 2 x USB 3.0 and glass on the side makes this perfect. NOTE: My only piece of advice is that if you want the PSU shroud all the way across (my personal choice) you will be limited to either 2x 120mm fans or 2 x 140mm fans at the front. You have to remove part of the shroud which means you can see some cables.

I got this case for my first build and made sure it would fit a 3070ti. Please note, it does, however you will not be able to fit 2 fans on the front for intake. I had to move the already installed fan all the way to the top, and was able to install the card no bigge. However, in order to get 2 more fans for intake, I had to buy 15mm fans. 1 went in fine right infront of the card, the other, again please be aware when buying this case and you want 3 intake fans, the hardrive cage is in the way of the third fan. This is all to be expected as this isnt a super huge case its meant to be mid tower. Please note you are able to remove the cage it is screwed in with 2 tiny screws, however 1 of the screws you cannot fit a driver in as the front casing of the case is in the way, so i used a very thin and long screwdriver and managed to unscrew it. That is the only bad design I can give with this. You wont fit 3 fans on top for outake, only 2, and 1 on the back. Overall fantastic case just please note this is possible with 3 fans and a 3070ti there are just some complications. The glass panel is fantastic, the back panel is also amazingly easy to remove. Loads of spaces to run your wires so for my first build this was the best experience ever.

Great case, more than enough room for everything you need. I have recommended this case to a few friends as it has fantastic airflow if you set your fans up correctly.

Çok kaliteli İçinde: Gigabyte X570 I Aorus Pro Wifi, Ryzen 5 3600, MSI 2070 Super Ventus OC. Noctua NH-D15, önde 2x Noctua NF-A14.

Das Meshify C in weiß ersetzt ein Silverstone Gehäuse (Grandia GD09), welches mir etwas zu flach war für einej größeren CPU Kühler. Nach einiger Recherche fiel diese Wahl auf das Meshify C in weiß von Fractal Design, was ich keine Sekunde bereut habe. Ich hatte bisher noch nie so ein schickes, hochwertiges, sauber konstruiertes und aufgeräumtes Gehäuse! Die Optik ist ja immer Geschmackssache, aber mir gefällt das weiß (passt auch zur Einrichtung). Einbau der Hardware (Ryzen 7 2700x auf MSI B450 Tomahawk) gestaltete sich problemlos, die Kabel sauber zu verlegen ist wirklich eine Freude, da hier ausreichend Platz und genug Durchführungen vorhanden sind, sie laufen alle hinter bzw am Mainboard entlang und kommen nur zum Anschluss durch (z.T.) kleine Gummimanschetten auf die Vorderseite zum Mainboard. So ist das wirklich ein ganz anderer Schnack, top! Ausreichend Platz für Lüfter ist vorhanden, die beiden beigelegten kamen mir jetzt nicht besonders laut vor, aber meine eigenen von bequiet (Pure Wings 2 PWM 120mm) laufen noch etwas leiser. Der Noctua CPU Kühler (relativ flach wg Platz om alten Gehäuse) wirs heute durch eine AIO Wasserkühlung von Enermax ersetzt (Aquafusion 240,ebenfalls in weiß). So macht das PC Basteln wieder Spaß und man hat eine nette Ablenkung und Beschäftigung im Lockdown.... Das Gehäuse ist knapp 40cm tief und passt somit perfekt in unseren TV-Schrank eines großen, schwedischen Möbelhauses. Es gäbe auch eine größere Variante (Meshify S2...?), die ist nochmal 10cm tiefer und bietet somit noch mehr Platz und Möglichkeiten. Mir reicht diese Version und ich kann sie uneingeschränkt weiterempfehlen!

Fantastic product that is will made and, as a complete novice, was very intuitive to build in. To get the most out of this case I highly recommend 2 front intake fans. I went with two 140s from Phanteks and moved the stock intake to the top back as an additional exhaust. There is scope to throw a few extras in if you are super keen but I am comfortable with what I have. This case also has no trouble fitting my massive Noctua tower cooler or the 140 fan attached to it. Dust covers are easily cleaned and removed. If you are looking for a custom look the front panel comes with a number of different colours if you are happy to dish out the dish.

Boitier très bien pensé, filtré devant, dessous, dessus, ce qui n'est pas si commun. Son design me plait toujours autant depuis que je l'ai acheté et que je le compare aux modèles plus récents. Je pense que la plupart des gens qui assemblent leur PC, savent de quoi il en retourne au sujet de ce boitier de chez Fractal.

Estoy encantado con la compra. Llevaba mucho tiempo queriendo comprarla y fui demorando la decisión hasta que bajó un poco de precio. Me llegó dentro del margen que se establecía pero porque me dio por mirar en la página de SEUR con su tracker, ya que habían escrito mal la dirección. Al día siguiente, luego de haber escrito la correcta ya la tenía en casa. Venía muy bien protegida en su caja con su corcho. Me sorprendió que era más ancha de lo que creía pero para bien. Me parece muy estética, la malla frontal es preciosa (compré el modelo blanco con cristal templado) y los materiales se perciben de buena calidad y rígidos. El montaje ha sido súper fácil. Dentro de la bahía para los discos duros de 3'5 (también se pueden instalar de 2'5) se encuentra la cajita con los tornillos necesarios para toda la build y una herramienta para instalar los stand-offs (se agracede mucho). Por si os interesa mi setup se compone de un Ryzen 5 3600, MSI Tomahawk MAX, Noctua NH-D15 (sé que es un overkill para el Ryzen pero quería un cooler future proof), Corsair Vengeance LPX 2x8 3200 CL16, Gigabyte GeForce 1070 G1. El NH-D15, que es enorme, me cabe perfectamente con la RAM nombrada. El ventilador secundario lo he tenido que subir un poquito solo por la presencia de los módulos. La torre trae dos ventiladores Fractal Design gp-12 de 120mm; uno de intake y otro de exhaust. Para mi build he comprado dos Noctua NF-P14s redux-1500 (140mm) para mejorar el airflow, y los he puesto de intake y he colocado el frontal de 120mm en la parte de arriba de intake. Así consigo una presión positiva dentro de la torre y el aire sale por todas las rendijas, para que no se me acumule el polvo tan rápido. La volvería a comprar seguro y se la recomiendo a todo el mundo, aunque eso si, hay que invertir un poco más en ventiladores para sacarle todo el provecho al flujo de aire que esta torre permite.