rabbitgoo Heat Reflective Window Film Privacy Film for Glass Windows, One Way Mirror Tint Sticker Sun Blocker, UV Glass Sticker Mirror Heat Reflector Thermal Solar Vinyl Silver 44.5x200cm

I ordered this for the glass front of my Tortoise enclosure. It works really well even with the sliding doors. I also found it easy to install. I really like that it let's the light in to the enclosure but still provides a border so my Tortoise feels safe.

Rabbitgoo 60 x 200 cm “One Way” window film. It does what I needed. It was OK to put up, if one is careful, otherwise it might be a nightmare. The privacy only works for those inside if the peeper outside has brighter light than in the room and then they only see a reflection, this is usual during the day, but the reverse at night! So draw the blinds at night. It reduces radiant heat input very significantly. This is why I bought it, and it works much better than the so-called e-coating on the glass (I paid for it, but is there any? Is this a common double-glazing con?) However, it is not as good as a proper dichroic film. I needed to reduce the insolation through our glass doors, and while I bought these rolls a year ago I only applied them last week. It has made a big difference! Before film, inside floor temperature in the sun measured at 36°C, compared with the shaded part at 24°C. Later, when it had all cooled down again, I installed the film. Next day at the same time the bright part of the floor was 28°C and the shaded part 25°C. The step outside was 45°C. I've also added it to some south facing bedroom windows. My pic shows a very thin line of unfiltered daylight down the trimmed edge of the film, in focus but the garden view is of course out of focus. How it might be done if you are as OCD as me. 1. Clean the glass and the surrounds very carefully, removing all contaminants, especially traces of Windowlene or Flash, etc. 2. Check the scalpel/craft knife is very sharp. 3. Fill a clean spray bottle with water and a drop of Fairy liquid to work as a wetting agent. Use this solution and a clean old soft J-cloth for a final clean of the surface. 4. Move the Clear Film sticky tab to the side at the top, this will make peeling it off later much easier. 5. Stick some generous tabs of Sellotape on the film across the top, one each corner and one (or two) in the middle depending on how wide. This is so the film can be given a first position hanging in place from the frame by the sellotape; now it is easy to adjust and trim as necessary to make sure it covers all the glass with a small margin of about a centimetre at the sides, and maybe a bit more top and bottom. 6. Spray the glass generously, so it’s running with water. 7. Carefully begin peeling down the clear film from the sticky back of the silver film, keeping it all away from the glass. An assistant can help here, because now is also a good time to spray the back of the silver film, but it is possible for one person with a narrower glass. 8. About halfway through peeling, check the centre of the silver film is hanging true, and now is a good time to begin helping it to stick, but only with a light brush down the wetted centre, simply to control it. 9. Remove the rest of the clear film, paying attention to the centre and hanging true, and covering all the glass. 10. If it is in the correct position, only now begin to gently work the water out to the edges, radially from the centre, initially using another soft cloth. Use a squeegee only when the film is secure and wrinkle free, and always work towards the edges from the centre. 11. Once the film is stable, sellotape removed, most of the water excluded, and the edges are well worked into the corners and glazing seal, then trim it with the craft knife. Try and do it with a single firm pass along each edge (without damaging the rubber seal), ideally use a ruler to keep the film flat and guide the knife tip. Pay careful attention to the corners which are guaranteed to try and mess things up. 12. Finish off with the soft cloth, paying attention to the edges and seals. 13. Do not overwork the film; this can introduce wrinkles because it is more likely to stretch after a good soak. 14. Allow it to dry overnight, maybe a couple of days even, before succumbing to the temptation to tidy it up a bit more.

This is so easy to apply this is my first time ever doing this and it is so simple I was expecting to struggle but not at all this product is perfect for me bc I can’t pull my blinds down bc things are in the way and it stops the sun from blinding me in the morning and the appearance is beautiful is very good for privacy and I got the perfect size it covers 2 windows and about a half but I haven’t done the other one up yet and still let’s a lot of light thru definitely recommend and I will show the difference in lighting

Good window film that adds privacy and reduces glare. Once installed it works well and gives the window a nice reflective finish. It does take some time to cut and fit perfectly, so a bit of patience is needed during installation. Once in place though it looks good and does the job well.

It somewhat works. However please be aware that this makes your house constantly dark. It feels like your house is constantly at 4:30pm in December when it is starting to get dark. Doesn't matter how sunny/bright it is outside, you will still have no sunlight coming in. I have had to sit with lights and lamps on all day meaning that people can now see into the house from outside as its bright inside. I have always had some form of mirror film on my windows and yes it does make it slightly darker but this is very strong stuff. It is super easy to install, but I will be removing and replacing with something not to dark as I feel like i'm living in a morgue due to how dark and depressing its made my house feel.

This is the 3rd roll that I buy. I first bought it some years ago to use on a rented house for privacy. I'm now renting a flat and decided to buy it again. I am not the most patient person in the world and perhaps I lack the skills but I find it a bit challenging to attach it on my own, I feel like 2 hands are not enough. It's doable but ended up with tiny bubbles which could perhaps be prevented but I ran out of patience. When I have another set of hands for help, there are no bubbles left, but it still takes effort to make sure it's straight. The corners are a pain in the rear as they don't seem to stick on the glass properly but it's hardly noticeable. I love the end result anyway and I absolutely love the thickness and texture of it. It gives great privacy without losing brightness. I bought it before, bought it again and will definitely continue buying it in the future.

Great quality item that was very easy to apply. Bought this for my garden office and applied easily. When applying make window and film very wet with a spray bottle with a few drops of Fairy liquid inside. Majority of bubbles squeezed out when applied then some remaining bubbles disappeared over the following week. Really stops the garden office getting very hot in a sunny day which is great.

So i got two rolls of this, first the colour its not the same as the photo more like a rose gold its very pretty. Putting it on wasnt as hard as I thought, but I have one large window and it will just not stay put on that window, I have it in 4 other smaller windows and its stayed put, but the biger your window it seems less lively to say put. Its fallen off multiple times and iv replied it multiple times its now damaged from it coming off, im not willing to get another roll for ut to just not stick. im gutted coz it is really pretty up and stops my creepy neighbour coming standing in my window looking at me.