CryoGrip Pro Frostbite257x257 MM

剥がれづらいので良いです。それでも剥がれちゃった場合はこのプレートで温度上げて使ってます。65℃ぐらい。それが良いことなのかはわからないけど問題なさそう。

Muy buen producto

This is a very awesome build plate it has now became my main build plate for all my 3D printing projects everything sticks to it like glueUpdate: I've had this build plate for about 3 months now and it worked great I've printed multiple projects using this build plate had no problems with it but now I'm starting to have issues with adhesion the filament seems to have trouble sticking to the plate in some areas I've tried wiping it down with alcohol I've tried washing it with soap and water sometimes that works sometimes it don't and whatever stuff that's on the plate that makes prints stick to it it's starting to rub off on the corner. But it's still a very good build plate I would definitely buy another just know that it doesn't last for very long

The BIQU CryoGrip Pro Frostbite build plate has been an excellent addition to my 3D printing setup. I've used it with both PLA and PETG, and the results have been outstanding.Bed adhesion is fantastic! Everything I've printed sticks securely to the plate, and once the print is finished, removing it is as simple as flexing the plate. No scraping, no struggling to remove prints, and no worries about damaging the print or the build surface.One of my favorite things about this plate is how little maintenance it requires. Unlike traditional build plates, where fingerprints and skin oils can cause adhesion problems, I haven't had to worry about touching the surface. In fact, I've never even needed to clean mine, and it continues to perform flawlessly.For anyone who does a lot of 3D printing, especially with PLA and PETG, this plate makes the entire process easier and more reliable.Overall, exceptional adhesion, effortless print removal, and virtually zero maintenance. Easily one of the best build plates I've used, and I highly recommend it!

Put this on the P2S the week it showed up and it has been the bed I reach for ever since. First layers stick without glue or a brim even at room temperature, and when a print finishes the part lifts off with a light pull once the plate cools, no scraper and no bending the plate like a PEI sheet. Two months of use on mine, and after one PETG project left a glossy residue on the surface a wash in the sink with dish soap got it back to full stick; no warping and no peeling coat so far.Two things the listing does not tell you. The P2S throws an error every startup because it cannot read this plate's code, so you clear the message and print anyway, it is a nag not a fault. And parts come off the blue surface glossier than the stock textured plate, which is fine for functional parts but not if you want that rough bottom. The warped-out-of-box reviews are real though, so lay yours flat on a table before you trust it. If you print constantly, this earns its keep.