hygger Aquarium Light Clip Holder (for HG-978) (1), Aquarium Fish Tank Light Riser/Holder/Bracket/Stand/Mount

Awesome buy. Fits perfectly at the back of my aquarium and can extend higher or lower as needed. It holds the light I already high. Looks very expensive.

Work great from my tank and plants and lights

Screw mounts on the aquarium frame is too high to properly set the screws in beneath the frames to hold the light properly. The two brackets could not support my 36 inch 978 model due to the poor mount screws. It sagged and fell immediately. Support screws should have cut lower to set below the plastic rim frame. This is the worst holder.I went with a floor reptile lamp holder, and held the lights with thin steel wires. Much sturdier support and cleaner look for my 36 inch 978 light.

Overall I am very pleased with this purchase. This allows me to get the Hygger light virtually off the top the 47 gallon aquarium and the acrylic covers. This positioning did not allow me to lift those covers off for maintenance easily at all. Several things of note, however: 1. Both of the short screws used in the assembly on both units were VERY difficult to screw in and adjust. Even after using WD 40 on them it was a real struggle to get them onto the units. 2. For me, the extension of the light out over the top of the aquarium was not what I was hoping for. It's ok, but would've appreciated a greater reach toward the front of the tank be able to adjust where the light source fell best for my plants. We'll see how it works out. 3. The build is very solid which is appreciated!!

Works great, holds well, and doesnt look bad. I reccomend getting 2 if your light is over 24 inches.