24AWG, 15CM / 6''

these jumpers work really well, and they are good quality. i found myself in the situation where i had lots of M-M jumpers, and i had lots of M-F jumpers, but almost no F-F jumpers. i got the short ones so i can stick one on the end of an M-F jumper to get an F-F jumper. i figure if i need longer F-F jumpers, and i want them to be one-piece, i will just order a pack of longer ones.

The wires are great. They are a great length, and they go great inside the breadboards. The square ends are also great for wires that are in close proximity.

These are good quality, comparable to jumper purchased from Sparkfun and others. Price is very good. These work well for personal use, but durability not as good as solid "machine pin" jumpers.

I bought the F-F and M-M versions of this cable for some prototyping work. They worked great on the breadboard for point to point connections, and when it was time to move the build onto a PCB and into an enclosure, I even cut the ends off some of them to solder them to LEDs, switches, and connectors, using jumper pins on the circuit board for easier build/assembly. The wire strands were easily soldered.

These red and black jumper cables are great! Usually when you get a bunch of jumper wires there are only a few red and black wires. With this set, they are all red and black! They are good quality and the perfect length for all of my projects. No more hunting around for red and black cables for me!

I've used a couple of these now and they are nice. High quality pins & sockets.

The wires are exactly what I needed. They worked as advertised and seem well constructed. I did not have any issues with the connections coming loose. Great variety of colors and worked/works great for my projects.

Other jumpers I've purchased have had marginal connectors, bad wire, or both. These jumper wires seem quite good. The connectors are proper crimp type and the wire strand count, material, and gauge seem as advertised. For a quick test, I ran an absurd current (~10 amps) through one of the 30cm MM jumper and the applied voltage was only 0.32 volts. I'm very happy with this purchase.

These are very good quality jumper wires. Far better than the usual ribbon cable ones. Heavier wire and easy to cut and solder. (often the wire in these type of jumpers is so bad it doesn't solder well.)WOULD BUY AGAIN